Hal-Lock
Locking Outrigger Pulley Clip

For use with any outrigger where a double back is desired!

HAL-LOCK eliminates the need to tie the outrigger halyards together with rubber bands or wire, or using a sliding swivel arrangement. While these methods may temporarily solve the problem, they are time consuming and unsafe. I think most would agree that reaching out over the side of the boat with both hands tying halyards together is not the safest place to be in rough seas. And, there are more important things to do than waste time tying and untying halyards together. This

The HAL-LOCK outrigger pulley was specially designed for speed and efficiency (and it looks good too). Simply pull the locking lever back and the halyard is pushed into the softer urethane insert locking the halyard in place. That Easy! That Fast!, and because of HAL-LOCK’s unique ability to lock, very little tension is required on the shock cord, allowing you to get your clip up and back down with less effort

Model - HL-12 - Black - Single Pulley 12 inches long

Model - HL2-12 - Black - Double Pulley 12 inches long (shown in picture)